|

5/21/21

1st job: Customer informed me that refrigerator was not cooling. First thing I do is go straight to the evaporator coil This is a picture of the evaporator coil. As you can see here it is completely dry. What you are supposed to see is a thin sheet of ice on the coil, the ice…

5/19/21 work day

1st job: I had a call today in regards to a refrigerator not dispensing water, first thing I did was pull out the schematic so I can see where to put my leads in order to test the voltage of the water dispenser valve. Before I checked the voltage though I disassembled the dispenser to…

5/17/21

1st job: My first job today was  DCS 30″ commercial oven, the customer had told me that the oven would not ignite, the burner or the broiler. This job took me roughly 3 hours due to my lack of familiarity with this particular oven, I managed to find a service manual through one of my…

|

5/14/21 Work Day

1st job: I received a call from the customer that their dryer was making a squeaking noise. I arrive and disassemble the dryer. Now typically when the dryer is squeaking it is the rollers, or the idler pulley. In this case I swapped both the back rollers and applied lubricant to the idler pulley, once…

|

5/13/21 Work Day

1st job: I received a call in regards to a frigidaire side by side refrigerator that is not dispensing water or ice.   This was a fairly easy diagnostic, upon arrival the dispenser was dispensing water but at a low volume so I knew that the control board wasn’t faulty. I looked inside at the…