Regal Appliance Services LLC
1st job:
This was a call in regards to a Frigidaire Laundry Center. The complaint is that the machine will not go into the spin cycle it will only agitate….
I pull the machine apart and check voltage from the board, there is no voltage coming from the motor, this could be a board issue as well, but I am confident it is just the motor….
1st job: This was a quick job, the door latch for this customer was faulty I had to switch it out…. Anyways it took me about 30 minutes, I had to use screw driver and putty knife to compress both the top and bottom and pull it out, it took me longer than expected. Ultimately…
1st Job: I went back to a previous customers house in regards to their oven and washing machine, for the oven the broiler and gas valve needed to be tested, however the rusted screws prevented removal of the compartment enclosing the broiler and gas valve, I tried to drill it off with a drill bit…
1st job: This job was in regards to a GE Gas Oven. The complaint was of a gas smell when the oven is turned on. This could be two things, a weak igniter, a faulty gas valve, or a leaking gas line. First thing I do is check the amps of the bake igniter, only…
1st job: Had a call from a customer in regards to their washer making a strange sound when operating. I got there and noticed the wash plate was loose and shaking a great deal. I noticed some coins stuck in the sides, I tried to remove it but the bolt was rusted on too tight,…
1st job: This was a washer job (maytag)…..The customer is complaining about a loud noise while the washer is spinning, I determined that it was the gear case for the machine, the total cost would be at least 500 dollars, the customer declined the repair…. 2nd Job: This was a call for a sub zero…
1st job: The complaint is that their Whirlpool Oven, will not heat up. I run some tests, it is the igniter so I change it…. 2nd job: This was in reference to a Whirlpool Direct Drive Washer. The washer was not entering the spin cycle, my tests narrowed it down to the timer or…